## 打开它会减低一点点速度, 没事不要开 (用 IDE 的当然不用了)
#options BOUNCE_BUFFERS #include support for DMA bounce buffers
## 要用 IP-Firewall 才需要，你可以用 LKM 载入
#options IPFIREWALL #Firewall code
#options IPFIREWALL_VERBOSE #Print information about dropped packets
#options IPACCT #Used with ipfirewall
## 要用 IP-Firewall 或要当 router 才要
## 在 2.2-960323-SNAP 后已废除, 以 sysctl 打开 (見 /etc/sysconfig)
#options GATEWAY #Internetwork gateway
## Multicast routing, 做多路由器时用
#options MROUTING # Multicast routing
## 允许 swap device 的数目 (內定 20)
#options NSWAPDEV=20
## 指定 root partition 在那个硬盘上
#在第一个SCSI HD上
config kernel root on sd0
#在第一个IDE HD上
#config kernel root on wd0 dumps on wd0
## 使用 ISA 总线
controller isa0
## 使用 EISA 总线
#controller eisa0
## 使用 PCI 总线
controller pci0
## 软驱控制器
controller fdc0 at isa? port "IO_FD1" bio irq 6 drq 2 vector fdintr
# 软驱A
disk fd0 at fdc0 drive 0
# 软驱 B
# disk fd1 at fdc0 drive 1
## IDE 硬盘控制器
controller wdc0 at isa? port "IO_WD1" bio irq 14 vector wdintr
disk wd0 at wdc0 drive 0
disk wd1 at wdc0 drive 1
## 第二个 IDE 硬盘控制器, 有接第二个IDE控制器时才用
#controller wdc1 at isa? port "IO_WD2" bio irq 15 vector wdintr
#disk wd2 at wdc1 drive 0
#disk wd3 at wdc1 drive 1
## IDE(ATAPI 规格) 光驱
#options ATAPI #Enable ATAPI support for IDE bus
#options ATAPI_STATIC
#device wcd0 #IDE CD-ROM
## SCSI 控制卡, 请从 /sys/i386/conf/LINT 中读取详细说明
#controller ahc0
#controller ncr0
#controller bt0 at isa? port "IO_BT0" bio irq ? vector btintr
#controller uha0 at isa? port "IO_UHA0" bio irq ? drq 5 vector uhaintr
#controller ahc1 at isa? bio irq ? vector ahcintr
#controller ahb0 at isa? bio irq ? vector ahbintr
#controller aha0 at isa? port "IO_AHA0" bio irq ? drq 5 vector ahaintr
#controller aic0 at isa? port 0x340 bio irq 11 vector aicintr
#controller nca0 at isa? port 0x1f88 bio irq 10 vector ncaintr
#controller nca1 at isa? port 0x350 bio irq 5 vector ncaintr
#controller sea0 at isa? bio irq 5 iomem 0xc8000 iosiz 0x2000 vector seaintr
## SCSI 总线支持, 使用 SCSI 必备的
#controller scbus0
## SCSI HD SCSI硬盘
#device sd0 #Only need one of these, the code dynamically grows
## SCSI CDROM SCSI光驱
#device cd0 #Only need one of these, the code dynamically grows
## SCSI tape SCSI磁带机
#device st0 #Only need one of these, the code dynamically grows
## SCSI optical disk (MO) SCSI的MO驱动器
#device od0 #Only need one of these, the code dynamically grows
## SCSI media changers (Juke-Box)
#device ch0 #Only need one of these, the code dynamically grows
#------------------ 用AT-总线的光驱 (非 ATAPI，现在很少了吧) ---------------
## Mitsumi CDROM 美上美光驱
#controller mcd0 at isa? port 0x300 bio irq 10 vector mcdintr
## SONY CDROM 索尼光驱
#controller scd0 at isa? port 0x230 bio
## Panasonic CDROM 松下光驱
#controller matcd0 at isa? port ?
## QIC tape QIC磁带机
#device wt0 at isa? port 0x300 bio irq 5 drq 1 vector wtintr
## console 屏幕驱动程序, 这是必备的，少了启动不了
device sc0 at isa? port "IO_KBD" tty irq 1 vector scintr
## 调用 FPU 的机制, 无论有无 FPU 都要有, 都是必要的
device npx0 at isa? port "IO_NPX" irq 13 vector npxintr
## COM1 到 COM4 串口设备1-4
device sio0 at isa? port "IO_COM1" tty irq 4 vector siointr
device sio1 at isa? port "IO_COM2" tty irq 3 vector siointr
#device sio2 at isa? port "IO_COM3" tty irq 5 vector siointr
#device sio3 at isa? port "IO_COM4" tty irq 9 vector siointr
## Joystick 操纵杆设备
#device joy0 at isa? port "IO_GAME"
## 如果你有 Logitech or ATI InPort 总线鼠标的卡, 就要將此打开
## 請注意一般人使用的是 serial mouse 不是 bus mouse
#device mse0 at isa? port 0x23c tty irq 5 vector ms
## 给 PS/2 mouse 用的
#device psm0 at isa? port "IO_KBD" conflicts tty irq 12 vector psmintr
#options PSM_NO_RESET
## 打印机端口
device lpt0 at isa? port? tty irq 7 vector lptintr
#device lpt1 at isa? port? tty
#device lpt2 at isa? port? tty
## 网卡, 读一下 /sys/i386/conf/LINT，注意PCI卡不用指定硬件资源，系统会自测
文章整理：西部数码--专业提供域名注册、虚拟主机服务
http://www.west263.com
以上信息与文章正文是不可分割的一部分,如果您要转载本文章,请保留以上信息，谢谢!
