*************************************************************************************************************************************
The correct method for executing OpenBoot probe commands is to reset the system before entering the command. You must type reset-all as the first OBP command,then invoke the desired probe command, as shown:
ok reset-all
ok probe-scsi-all
*************************************************************************************************************************************
OpenBoot Diagnostics(OBDiag) reside in flash PROM on the main logic board. it is available only on the Enterprise 250 and Enterprise 450 at this time
OBDiag can isolate errors on the following system components:
main logic board
diskette drive
CD-ROM drive
tape drive
hard drives
any card installed containing on-board self-test
文章整理：西部数码--专业提供域名注册、虚拟主机服务
http://www.west263.com
以上信息与文章正文是不可分割的一部分,如果您要转载本文章,请保留以上信息，谢谢!
